🔥DEAL 50% OFF 🔥Vixnest™ Pneumatic Dent Puller
🔥DEAL 50% OFF 🔥Vixnest™ Pneumatic Dent Puller
✔️ Pops Dents in 60 Seconds Seal, Pull, Pop
✔️ No Glue. No Drilling. Paint-Safe Vacuum
✔️ 3 Cup Sizes Door Dings to Palm-Size Dents
BUNDLE & SAVE
Couldn't load pickup availability
🔥DEAL 50% OFF 🔥Vixnest™ Pneumatic Dent Puller
-
I connected it to my compressor, selected the right cup, and worked the dent out with a few controlled pulls. No glue mess and no drilling. A genuinely useful tool to keep in the garage.
-
The slide hammer feels sturdy and the suction held well on a clean, smooth panel. Setup was straightforward, and the three cups gave me more flexibility for different repair areas.
-
Once I paired it with a compressor that could maintain steady airflow, it worked exactly as expected. The cup stayed secure and gave me plenty of pulling force for a shallow dent.
Cup Expansion Pack
Watch the Dent Pop Back Out
Seal the cup over the ding, open the valve, and give the slide hammer a few solid pulls. Little by little the metal walks back to shape no filler, no respray, no waiting room. It ain't magic: if the paint's intact and the dent has no sharp crease, it's a candidate. That covers most door dings, shopping-cart hits and shallow hail damage.
Kind to Factory Paint
Hot-glue kits leave residue and can lift clear coat when you twist the tabs off. Stud welders literally put holes in your panel. Vixnest grips with vacuum only clean the panel, seal the cup, pull the dent, keep the finish your car left the factory with.
Runs Off the Compressor You Already Own
Snap the 1/4" quick-connect onto your garage compressor hose, flip the red lever, and the solid brass valve builds serious vacuum grip in seconds. No batteries, no glue gun heating up, no drilling into your panel the same pneumatic principle body shops use, sized for your garage.
Frequently Asked Questions
Will it work on my dent?
Will it work on my dent?
Built to handle a wide range of dents including door dings, shopping-cart hits, parking bumps, broad panel dents, and shallow hail damage. Its pneumatic suction and controlled pulling force adapt to different dent sizes and panel areas, giving you a versatile tool for everyday auto-body repairs.
Do I need an air compressor?
Do I need an air compressor?
Yes. Vixnest runs on the compressor in your garage. It connects with a standard 1/4" quick-connect fitting, and even a small pancake compressor has plenty of air for it. No compressor, no pull vacuum grip with no glue.
Will it damage my paint?
Will it damage my paint?
No glue, no drilling, no heat. The cup grips with pneumatic vacuum only, so your factory finish stays put. Clean the panel first so the rubber seals well, and release the valve before lifting the cup off.
Which panels does it work on?
Which panels does it work on?
Steel and aluminum body panels: doors, fenders, hoods, quarter panels, tailgates and roofs. It is not for plastic bumpers, trim, or glass - plastic flexes instead of holding a vacuum pull.
Do I need experience?
Do I need experience?
If you can hook up an air hose, you can use it. Connect, seal the cup over the dent, open the valve, and work the slide hammer with steady pulls. Most first-timers see their dent moving inside 60 seconds. Go slow and work from the shallow edge of the dent inward.